CAT CAMS camshaft for RENAULT Alpine 1.4L 8v engine code 840.726
Here are our camshafts from Cat Cams for RENAULT Alpine 1.4L 8v engine code 840.726
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for RENAULT Alpine 1.4L 8v engine code 840.726
Rally and circuit profile:
- Cat Cams camshaft reference: 5506227/C / Opening 0.1mm inlet 287°, exhaust 287° / Opening 1.0mm, inlet 244°, exhaust 244° / Max lift inlet 10.45mm, exhaust 10.45mm / Lift at TDC inlet 2.60mm, exhaust 2.60mm / Full opening inlet 110° exhaust 110° Attention modifications to be expected: pulley : reference TRE012.
Cam lobe sequence: EI-EI-EI-EI (cross flow head) - overall length: 455 mm (with water pump drive) - double chain - journal diameters: 37.94 - 37.94 - 37 .94 - 34.48 mm - available only in billet steel. FOR COMPETITION REQUESTS ONLY. The following details should be checked: - The camshafts should turn smoothly in the cylinder head, ensuring free stroke by machining where necessary - The distance between the valve seal and the retainer at full lift should be d 'at least 0.6 mm - A minimum valve spring travel of 1.0 mm at full lift must be provided - distance between valve and piston 1.0 mm (pref. 1.5 mm). check 5-15° before TDC on the exhaust, and after TDC on the intake. For use ONLY in competition engines with independent engine management (throttle position sensor) or carburettors.
ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
High performance camshaft and pulley manufacturer
You might also like