Here are our camshafts from Cat Cams for FIAT 4 cylinders 16L 8v
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for FIAT 4 cylinders 16L 8v
Sports profile :
-
Cat Cams camshaft reference: 1900300/S / Opening 0.1mm, intake 280°, exhaust 280° / Opening 1.0mm, intake 244°, exhaust 244° / Max lift intake 10.65mm, exhaust 10.65mm / Lift at TDC intake 2.50 mm, exhaust 2.50mm / Full opening inlet 110°, exhaust 110°.
There are 5 different reference ranges: 1 for each type of variator: PN19003xx: distributor mounted on the engine block (not driven by camshaft) PN19113xx: distributor driven by a sleeve at the rear of the camshaft exhaust - PN19133xx: distributor driven by a sleeve offset by 90° at the rear of the exhaust camshaft - PN19123xx: distributor drive pinion between the cam lobes of the exhaust camshaft, right sprocket - PN19143xx: distributor drive sprocket between the cam lobes of the intake camshaft, left sprocket. Please ensure you order the correct camshaft for your engine, matching the correct part number range. On the website only the part number range "PN19003xx" is displayed, the last two digits (xx) are the same for the same cam profiles.
Rally and circuit profile:
- Cat Cams camshaft reference: 1900317/S / Opening 0.1mm inlet 310°, exhaust 310° / Opening 1.0mm, inlet 269°, exhaust 269° / Max lift inlet 11.15mm, exhaust 11.15mm / Lift at TDC intake 4.50mm, exhaust 4.45mm / Full opening inlet 105° exhaust 105°.
/!\ ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
