Here are our camshafts from Cat Cams for
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for
Sports profile :
-
Cat Cams camshaft reference: 7107179/C / Opening 0.1mm, intake 260°, exhaust 256° / Opening 1.0mm, intake 227°, exhaust 220° / Max lift intake 11.00mm, exhaust 10.55mm / Lift at TDC intake 1.65 mm, exhaust 1.20mm / Full inlet opening 110°, exhaust 110° / Inlet clearance, 0.25mm, exhaust 0.25mm. Mechanical pushers.
Camshafts for 3rd generation 3S-GE engines. Please check the following dimensions before ordering: - Cam base diameter: 32.5mm - Cam follower diameter: 31.0mm - Shim diameter: 13.0mm (between valve and cam follower)
Rally and circuit profile:
- Cat Cams camshaft reference: 7107183/C / Opening 0.1mm inlet 292°, exhaust 285° / Opening 1.0mm, inlet 259°, exhaust 252° / Max lift inlet 13.00mm, exhaust 12.50mm / Lift at TDC inlet 4.20mm, exhaust 3.65mm / Full opening inlet 106° exhaust 106° Please note modifications to be expected:
- Cat Cams camshaft reference: 1303620/S / Opening 0.1mm intake 299°, exhaust 289° / Opening 1.0mm intake 269°, exhaust 255° / Max lift intake 14.45mm, exhaust 13.25mm / Lift at TDC intake 2 .00mm, exhaust 3.00mm / Full opening opening 129-69°, exhaust 114-76° Please note modifications to be expected: Valve springs reference PAC-D15009, Cups reference 99491, Mechanical tappets reference CC010 / Intake clearance, 0.25mm, exhaust 0.25mm.
/!\ ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
High performance camshaft and pulley manufacturer
You might also like