CAT CAMS camshaft for FORD 4 cylinders engine code ALDA

Here are our camshafts from Cat Cams for FORD 4 cylinders engine code ALDA

Description :

The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.

When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.

When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.

Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.

You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.

Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.

Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.

Without broaching the subject of driving pleasure which will increase your sensations tenfold.

Camshaft profile available for FORD 4 cylinder engine code ALDA

Sports profile :

• Cat Cams camshaft reference: 2291012/S / Opening 0.1mm, intake 269°, exhaust 261° / Opening 1.0mm, intake 236°, exhaust 227° / Max lift intake 11.50mm, exhaust 11.00mm / Lift at TDC intake 0.25 mm, exhaust 1.40mm / Full opening inlet 145°, exhaust 112°. 

Intake camshaft for use with VVT system (like stock intake). In the factory valve configuration, the valve clearance is adjusted by cam followers of individual lengths. Cat Cams offers two options for adjusting valve clearance: 1/Camshafts with a factory cam base diameter of 38.2 mm: Use OEM tappets with appropriate inner stud length to adjust clearance. may be necessary to replace the cam followers to obtain the correct valve clearance.2/ Camshafts with cam root diameter reduced to 35.0 mm: use lash covers (diameter 6 mm) of appropriate thickness to adjust the clearance--> Please indicate the diameter of the cam foot when ordering.

/!\ ATTENTION /!\

The camshafts are custom-made parts.

Therefore, we will not carry out returns, exchanges or refunds in the event of an error.

To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.