Here are our camshafts from Cat Cams for VOLKSWAGEN 3.2L 24v engine code BUB
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for VOLKSWAGEN 3.2L 24v engine code BUB
Rally and circuit profile:
Cat Cams camshaft reference 7607823/S / Opening 0.1mm, intake 280°, exhaust 268°/Opening 1.0mm, intake 233°, exhaust 221°/Max lift intake 12.00mm, exhaust 11.50mm /Lift at TDC intake 0.15mm, exhaust 0.50mm / Full opening inlet 130°, exhaust 119°.
Springs can be mounted directly to the cylinder head, use solid shims to adjust spring load if necessary PAC-D19864 double spring recommended over 8,000 rpm (in combination with 99391/s upper retainer and lower retainer 99537). Check valve seal clearance. The valve seal must be lowered for valve lift > 11.00mm. camshafts for use in BUB (3.2L) engines with VVT sprocket on intake and exhaust - ONLY for replacement of OE part number combination "022 109 102A" (intake) + "022 109 101E » (exhaust) - camshaft installation position: intake at maximum idle / exhaust at maximum - check valve at piston clearance. For available profiles, see BFH-BML VR6 motor profiles. Use 7607 8 xx to order the BUB version of these camshafts. It's a very complex engine. Camshafts should only be installed by experienced professionals who have the tools, skills and patience necessary for proper installation, verification and adjustment of timing events and all associated parts. Standalone ECU based on recommended throttle position sensor# - Intake valve: 1.8mm extra opening at TDC - Exhaust valve: 1.75mm extra opening at TDC CAREFULLY CHECK VALVE TO PISTON CLEARANCE .
ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
