CAT CAMS camshaft for VOLVO 4 cylinders 2.3L 8v engine code B230
Here are our camshafts from Cat Cams for VOLVO 4 cylinders 2.3L 8v engine code B230
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for VOLVO 4 cylinders 2.3L 8v engine code B230 :
Rally and circuit profile:
- Cat Cams camshaft reference: 7901414/C / Opening 0.1mm inlet 303°, exhaust 304° / Opening 1.0mm, inlet 275°, exhaust 272° / Max lift inlet 13.30mm, exhaust 13.00mm / Lift at TDC inlet 5.85mm, exhaust 5.55mm / Full opening inlet 106 exhaust 106 Please note modifications to be expected: Exterior valve springs reference PAC-E95009 / interior reference PAC-I95009, Upper cups reference 99326, Mechanical tappets reference CC009, Pulleys reference CTVO021, Pellets reference TS103
Please quote STD cam base diameter and cam height when ordering sport camshafts. Depending on engine version and application, additional modifications may be required. FOR COMPETITION REQUESTS ONLY. The following details should be checked: Camshafts should turn smoothly in the cylinder head, ensure free stroke by machining where necessary - distance between valve seal and retainer at full lift should be at least 0.6 mm - A minimum valve spring travel of 1.0 mm at full lift must be provided - valve to piston distance 1.0 mm (pref. 1.5 mm). check 5-15° before TDC on the exhaust, and after TDC on the intake. Use ONLY in competition engines with independent engine management (throttle position sensor) or carburetors. FLAT NOSE Cam Design
/!\ ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
High performance camshaft and pulley manufacturer
You might also like