CAT CAMS camshaft for CITROEN 4 cylinders 1.4L 8v engine code XY8
Here are our camshafts from Cat Cams for CITROEN 4 cylinders 1.4L 8v engine code XY8
Description :
The Cat Cams camshaft will allow you to considerably increase the performance of your vehicle.
When a vehicle must receive extensive mechanical preparation to obtain results worthy of the name and above all a significant range of progression, work on the camshafts becomes inevitable.
When preparing the Cat Cams camshaft, two modifications are observed: the valve lift and the opening angle.
Valve lift allows you to change the length and opening angle, which causes less or more air to enter the combustion chamber.
You should know that more air entering therefore modifies the air/fuel mixture in the cylinders, which increases power at high revs.
Also, the greater the opening angle of the valve, the more the air flow increases, which promotes the air/fuel mixture and therefore more power.
Therefore for use in competition, leisure, circuit and other, the revs will be sharper, the character of your engine will be more furious and thus you will benefit from a better range of use which will become a real asset.
Without broaching the subject of driving pleasure which will increase your sensations tenfold.
Camshaft profile available for CITROEN 4 cylinders 1.4L 8v engine code XY8
Rally and circuit profile:
- Cat Cams camshaft reference: 4910403/S / Opening 0.1mm inlet 324°, exhaust 324° / Opening 1.0mm, inlet 268°, exhaust 268° / Max lift inlet 11.85mm, exhaust 11.85mm / Lift at TDC intake 4.20mm, exhaust 4.20mm / Full opening inlet 106° exhaust 106°. Please note modifications to be expected: upper cup reference 99377 , external springs reference PAC-S99843.
FOR COMPETITION REQUESTS ONLY. The following details should be checked: - The camshafts should turn smoothly in the cylinder head, ensuring free stroke by machining where necessary - The distance between the valve seal and the retainer at full lift should be d 'at least 0.6 mm - A minimum valve spring travel of 1.0 mm at full lift must be provided - distance between valve and piston 1.0 mm (pref. 1.5 mm). check 5-15° before TDC on the exhaust, and after TDC on the intake. For use ONLY in competition engines with independent engine management (throttle position sensor) or carburettors.
- Cat Cams camshaft reference: 4900449/S / Opening 0.1mm intake 316°, exhaust 316° / Opening 1.0mm intake 260°, exhaust 260° / Max lift intake 11.50mm, exhaust 11.50mm / Lift at TDC intake 3.65mm, exhaust 3.65mm / Full opening inlet 107°, exhaust 107° Hydraulic pusher . Please note modifications to be expected: upper cup reference 99377 , external springs reference PAC-S99843.
FOR COMPETITION REQUESTS ONLY. The following details should be checked: - The camshafts should turn smoothly in the cylinder head, ensuring free stroke by machining where necessary - The distance between the valve seal and the retainer at full lift should be d 'at least 0.6 mm - A minimum valve spring travel of 1.0 mm at full lift must be provided - distance between valve and piston 1.0 mm (pref. 1.5 mm). check 5-15° before TDC on the exhaust, and after TDC on the intake. For use ONLY in competition engines with independent engine management (throttle position sensor) or carburettors.
/!\ ATTENTION /!\
The camshafts are custom-made parts.
Therefore, we will not carry out returns, exchanges or refunds in the event of an error.
To avoid any inconvenience, please ensure the correct compatibility of the camshafts and or contact us.
High performance camshaft and pulley manufacturer
You might also like