EGR Valve Removal Kit for OPEL SIGNUM 2.0 DTi 100hp and 2.2 DTi 125hp

Here is our EGR Valve Removal Tool from Dynaparts for OPEL SIGNUM 2.0 DTi 100hp and 2.2 DTi 125hp

This kit has been specially designed and developed for the 2.0 DTi and 2.2 DTi diesel engines from OPEL. It will allow you to remove your EGR valve by this kit.

This part is made of seamless aluminum and is manufactured IN FRANCE.

It will fit perfectly in place while following the instructions included in this kit. It will allow you to preserve your engine from breakage and fouling.

The assembly instructions with diagram are provided in the kit.

Complete kit ready to install, you just need to connect the blue/red wires using clips not supplied. Please note, it is essential to have a perfectly functional flow meter for assembly.

Made in France!

WHY install our kit?

for the reasons mentioned in the description below, and the main cause, to avoid engine breakage and fouling.

WHEN and HOW to install our kit?

This kit can be installed as soon as you can, especially do not wait. Even a novice in mechanics can do it with tools, you just have to replace your EGR valve with this one.

Over time, the EGR valves become clogged and therefore reduce the internal diameter of the air flows, which results in a loss of power and poor gas regeneration.

The EGR valve is an engine element that allows part of the exhaust gases to be recycled into the intake. They are burned a second time.

This technique clogs the intake manifold and causes engine problems.

The EGR valve removal kits or plates sold on https://strperformance.com/en/ will allow you to plug, block and remove the EGR valves. You will thus be able to reduce or eliminate any problem, in a curative and preventive way.

Our products are designed and developed on the vehicle valves directly and are fixed without major modification. In order to make your choice or in case of hesitation, compare the photos of our kits with your EGR valve mounted on your vehicle, or refer to the list of compatible engines below.

This kit was designed to be practical, it is mounted in place of the mechanical part of your EGR valve. You must remove the electrical part, then put this cap.

Then you can put the electrical part back, leaving it plugged in (if desired). The assembly is invisible!

Make your choice from the menu above regarding the Renault metal O-ring. Monobloc design, without welding. Made in France!

Example of compatible EGR valves:

• OPEL: 58 51 041
• OPEL: 58 51 594
• OPEL: 9 196 675

Example of compatible vehicles:

• OPEL SIGNUM 2.0 DTI 100hp
• OPEL SIGNUM 2.2 DTI 125cv