Electronic EGR Valve Removal Cap Kit for OPEL SAAB 2.0 2.2 DTI TID Y20DTH Y20DTR engine

Here is our electronic EGR valve removal kit with plug for OPEL SAAB equipped with a 2.0 2.2 DTI TID Y20DTH Y20DTR engine

This kit has been specially designed and developed for OPEL and SAAB 2.0 2.2 DTI TID Y20DTH Y20DTR diesel engines. It will allow you to remove your EGR valve by this kit.

This piece is made of seamless aluminum and is manufactured IN FRANCE.

It will mount perfectly in place while following the instructions included in this kit. It will allow you to preserve your engine from breakage and fouling.

The assembly instructions with diagram are provided in the kit.

Complete kit ready to install, it is just necessary to connect the blue/red wires using clips not supplied. Attention, it is imperative to have a perfectly functional flowmeter for the assembly.

French made !

WHY install our kit?

for the reasons mentioned in the description below, and the main cause, to avoid breakage and engine fouling.

WHEN and HOW to install our kit?

This kit is installed as soon as you can, especially do not wait. Even a person new to mechanics can do it with tools, you just have to replace your EGR valve with this one.

Over time the EGR valves become clogged and therefore reduce the internal diameter of the air flows, which results in a loss of power, poor gas regeneration.

The EGR valve is an engine component that recycles part of the exhaust gases into the intake. They are burned a second time.

This technique clogs the intake manifold and causes engine problems.

The EGR valve removal kits or plates sold on https://strperformance.com/en/ will allow you to plug, condemn and remove the EGR valves. You will thus be able to reduce or eliminate any problem, in a curative and preventive way.

Our products are designed and developed on the valves of vehicles directly and are fixed without significant modification. In order to make your choice or in case of hesitation, compare the photos of our kits with your EGR valve fitted to your vehicle, or refer to the list of compatible engines below.

This kit has been designed to be practical, it is mounted instead of the mechanical part of your EGR valve. You need to remove the electric part, then put this plug.

Then you can put the electrical part back on, leaving it plugged in (if desired). The assembly is invisible!

Make your choice in the menu above concerning the Renault metal O-ring. One-piece, seamless design. French made !

Compatible kit for:

ASTRA IV/G

• - 2.0 DTI (Y20DTH)
• - 2.2 DTI (Y22DTR)

FRONTERA II / B

• - 2.2 DTI (X22DTH, Y22DTH)

SIGNUM

• - 2.0 DTI (Y20DTH)
• - 2.2 DTI (Y22DTH)

VECTRA II/C

• - 2.0 DTI (Y20DTH)
• - 2.2 DTI (Y22DTR)

ZAFIRA I/A

• - 2.0 DTI (Y20DTH)
• - 2.2 DTI (Y22DTR)

SAAB 9-3

• - 2.2 TiD (D223L)

SAAB 9-5

• - 2.2 TiD (D223L)

If the broken EGR valve is open, the EGR cheater does not work. You then need to apply the blanking plate.