EGR valve removal cap kit for OPEL ZAFIRA 2.0 DTi 101cv and 2.2 DTi 125cv

Here is our Dynaparts EGR valve removal cap for OPEL ZAFIRA 2.0 DTi 101cv and 2.2 DTi 125cv

This kit has been specially designed and developed for the 2.0 DTi and 2.2 DTi diesel engines from OPEL. It will allow you to remove your EGR valve by this kit.

This part is made of seamless aluminum and is made IN FRANCE.

It will be mounted perfectly in place while following the instructions included in this kit. It will allow you to protect your engine from breakage and clogging.

The assembly instructions with diagram are provided in the kit.

Complete kit ready to install, it is just necessary to connect the blue / red wires using clips not supplied. Attention, it is imperative to have a perfectly functional flowmeter for the assembly.

French made !

WHY install our kit?

for the reasons given in the description below, and the main cause, avoid engine breakage and clogging.

WHEN and HOW to install our kit?

This kit installs as soon as you can, especially don't wait. Even a person new to mechanics can with tools, do it, you just have to replace your EGR valve with this one.

Over time the EGR valves become clogged and consequently reduce the internal diameter of the air flows, which results in a loss of power, poor gas regeneration.

The EGR valve is a driving element which recycles part of the exhaust gases into the intake. They are burned a second time.

This technique clogs the intake manifold and causes engine problems.

The EGR valve removal kits or plates sold on https://strperformance.com/en/ will allow you to plug, seal and remove EGR valves. You will be able to reduce or eliminate any problem, in a curative and preventive way.

Our products are designed and developed on vehicle valves directly and are attached without significant modification. In order to make your choice or in case of hesitation, compare the photos of our kits with your EGR valve mounted on your vehicle, or refer to the list of compatible engines below.

This kit has been designed to be practical, it is mounted in place of the mechanical part of your EGR valve. You have to remove the electrical part, then put this plug.

Then you can put the electrical part back on, leaving it plugged in (if desired). The assembly is invisible!

Make your choice in the menu above concerning the Renault metal O-ring. Monoblock design, seamless. French made !

Example of compatible EGR valves:

• OPEL: 58 51 041
• OPEL: 58 51 594
• OPEL: 9 196 675

Example of compatible vehicles:

• OPEL ZAFIRA (F75_) 2.0 DTI 16V 101cv
• OPEL ZAFIRA (F75_) 2.2 DTI 16V 125cv